AmpRecipe

Led Zeppelin guitar tone

A tone for the band, not for one recording: the sound they are known for, so expect to move a knob for any particular song. Nobody has played this one yet; it comes from a documented rig, not from ears.

Dial it in Guitar Rig 7 Player by hand, using only components the Player edition includes. A starting point nobody has played in this edition yet.

An amp modelled on a Fender Deluxe Reverb, through a Fender Deluxe 1x12 cab.

Knobs, in signal order

  1. Fire SeekerAmp

    • Gain, 3.5 of 10
    • Low, 5 of 10
    • Mid, 5.5 of 10
    • Treble, 6 of 10
    • Master, 6 of 10

    The recipe also sets presence and reverb, which Fire Seeker does not have. Leave its other controls where they load.

  2. Matched Cabinet ProCab

    • Cabinet, the one that loads with Fire Seeker

    The rig calls for a Fender Deluxe 1x12 cabinet. NI does not publish the names of the matched cabinets, so start from the one that loads with the amp and change it by ear.

  • Amp swapped: The Supro has no counterpart in Guitar Rig 7 Player; Fire Seeker stands in as a Lead amp, since this edition has no Clean amp and NI describes this one as covering clean sounds
  • Note: A plain number is the knob's own reading on a 0 to 10 scale unless the setting gives another range; %, Hz, dB and ms are the units the Guitar Rig 7 interface shows. Amp, drive and fuzz knobs are assumed to read 0 to 10.

Set your guitar

Pickups
two humbuckers
Position
neck
Tone knob
6-7
Channel
Clean

Where the rig comes from

  • A Supro was used for the entire first album and for the Stairway to Heaven solo, played on the 1959 Dragon Telecaster; the twelve string parts of Stairway were layered on a Vox Phantom XII and a Fender Electric XII; Page also used a Vox AC30 at times groundguitar.com
  • For Stairway to Heaven a settings guide suggests the neck pickup for the arpeggios, a tone knob around 6 to 7 for the softer sections and a guitar volume around 7 to 8; community opinion rather than documentation guitarchalk.com